James-loudspeaker A2.1 Amp Uživatelský manuál Strana 2

  • Stažení
  • Přidat do mých příruček
  • Tisk
  • Strana
    / 2
  • Tabulka s obsahem
  • KNIHY
  • Hodnocené. / 5. Na základě hodnocení zákazníků
Zobrazit stránku 1
1 - Power LED - Indicates the power state, no color - off, red - standby mode, blue - on.
2 - Master Volume - Controls the overall volume of the sats and subs together.
3 - Sub Volume - Used to set the relative level of the subwoofer volume to the sat volumes.
At MAX there is about +12dB more gain available over the sat levels, but this will vary
based on the efficiency of the sats and subs used.
4 - Sub Crossover - set the crossover point for the subwoofer between 40Hz and 150Hz. 80Hz
is marked as a reference.
5 - Sat Crossover - sets the crossover point for the sats. Turned all the way to the left, there is
a switch position which defeats the crossover and runs the sats full range. Once the con-
trol is rotated towards the 40Hz position, the crossover will be switched in and provides a
range of 40Hz to 150Hz. 80Hz is marked as a reference.
6 - 45Hz Boost switch - allows the addition of +4dB of bass boost for the subwoofer.
7 - Phase switch - switches the polarity of the subwoofer to allow better matching to the
sats in certain situations - the setting depends on the specific installation and James
recommends you start in the 0 degree setting.
8 - Rack ears - for rack mounting the amplifier - these can be removed if needed for shelf
mounting.
9 - Right sat speaker connection. Connect the red terminal to the positive on the right sat
speaker.
10 - Left sat speaker connection. Connect the red terminal to the positive on the left sat
speaker.
11 - Sub woofer speaker connection. Connect the red terminal to the positive on the subwoof-
er.
12 - 3 position Power switch - “OFF “turns the amplifier completely off, AUTO position for
signal sense on/off, and “ON” leaves the amp permanently on.
13 - Left/Right RCA inputs. A 1/8 miniphone to RCA cable is included for cellphone and tablet
sources.
14 - 120V/240V selector - make sure this is correctly set for your AC line voltage.
15 - IEC Power connection.
16 - Fuse holder/ spare fuse holder.
17 - Optional self-adhesive feet on bottom. These can be left off for rack mounting or
attached for shelf use.
535 Airpark Road
Napa, California, 94558 USA
www.JamesLoudspeaker.com
1-707-265-6343
1 2 3 4 5 6 7 88
9 10 11 12 13 14 15
1617
USER MANUAL
A2.1 AMp
NOTES:
Zobrazit stránku 1
1 2

Komentáře k této Příručce

Žádné komentáře